不同来源土样胶体对氯霉素吸附行为的影响

选取不同来源沉积物或土壤样品（沉积物A1和A2,天然土壤B1和B2,市售营养土B3）,采用切向超滤与多种纳米分析技术相结合的方法,分析了不同土样中胶体的理化特征及其对氯霉素（CAP）吸附行为的影响.荧光区域积分法结果显示,土样胶体的荧光组分以色氨酸类蛋白质、类富里酸和类腐殖酸为主,络氨酸类蛋白质和溶解性微生物代谢物质存在较少.吸附实验结果表明,B3胶体对CAP的吸附率最大（36.25%）,在胶体浓缩液和超滤液中的分配比例最高（1.91）,但其有机碳归一化结合系数最低（3.93）.与天然土壤相比,河湖沉积物胶体的吸附率较高,但其与CAP的结合能力却较低.冗余分析结果表明,胶体对CAP的吸附主要与其芳香度、有色溶解性有机质丰度、溶解性有机碳浓度及分子量有关;此外,胶体的腐殖化程度、芳环上羧基、羰基等官能团的比重及荧光物质中溶解性微生物代谢产物和类腐殖酸对CAP的吸附行为也具有较大影响.     

铁锰复合氧化物滤料去除地下水中四环素的效能

以化学挂膜成熟运行5a的铁锰复合氧化物滤料为研究对象,利用静态与连续流柱实验相结合的方式,探究了该滤料去除四环素的效果与机理.结果表明,去除过程符合准二级反应动力学模型;且滤料质量越大,初始浓度越高,对四环素去除的效果越好;当水中共存阳离子浓度为0.01mol/L时,Mg²⁺抑制四环素的去除,而Ca²⁺、K⁺对四环素的去除过程无显著影响.连续流柱实验与发光细菌毒性检测分析,表明,铁锰氧化物滤料对四环素去除效果显著高于石英砂,且铁锰复合氧化物滤料去除四环素后急性毒性降低.此外,机理探究实验结果证实了铁锰复合氧化物滤料去除四环素是吸附与氧化的过程.     

近三十年中国非点源污染研究现状与未来发展方向探讨

非点源污染是我国面临的重要环境问题之一,其影响范围广,污染不易控制,因此受到研究者和管理者越来越多的关注.中国非点源污染研究呈起步晚、速度快、范围广的发展特点,近十年来相关论文发表已达到一定数量,但是现有研究多是针对非点源污染体系中某些方面进行探究,缺少从全国尺度和长时间序列角度对我国非点源污染研究现状的梳理和总结.本文从全球主要文献库中检索了1988—2018年我国非点源污染的相关文章,挑选出1354篇文章进行统计分析,对于年发文数量、研究区所属省份、研究区所属流域、研究对象和研究方法分别进行统计展示.对我国近三十年非点源污染研究现状与存在问题进行总结,其中农业非点源污染需要继续深入探究其机理,城市非点源污染研究深度不足,研究地区有较大差异,研究方法存在复杂性与实用性的矛盾.未来中国非点源污染研究仍会以农业和农村非点源为主要研究对象;城市非点源将得到进一步发展;非点源污染物的防治与利用将成为重要的研究目标和研究方向;在国家实施的长江大保护战略及黄河生态保护高质量发展战略中,非点源污染也是关键研究问题;全球变化对非点源污染的影响也将是未来研究不可忽视的问题.本文对近三十年中国非点源污染研究规律进行了总结,探究发展变化原因,并提出未来发展方向,为污染源控制以及污染管理提供科学建议和决策支持.     

DOC+CDPF对国III重型柴油货车实际道路排放的影响

利用便携式车载排放测试系统（PEMS）对2辆加装氧化催化转化器（DOC）和催化型柴油颗粒捕集器（CDPF）与否的国III重型柴油货车进行实际道路排放测试.结果表明,2辆改造重型柴油车的CO、THC、固态颗粒物粒数（SPN）和黑碳（BC）实际道路排放因子分别为（1.31±0.37）g/（kW×h）、（0.20±0.03） g/（kW×h）、（7.13×10¹⁰±5.27×10¹⁰）个/（kW×h）和（0.69±0.06）mg/（kW×h）,相对于原始排放（拆除DOC+CDPF）分别降低52.48%、55.69%、99.91%和99.22%.从低速、中速到高速,CO和THC减排比例呈现上升趋势,然而运行工况对SPN和BC减排比例则无显著影响.加装DOC+CDPF会导致NO₂在NO_x中的占比升高,且从低速、中速到高速涨幅依次增大,但对NO_x无明显减排效益,其排放因子为9.53~9.83g/（kW×h）,远高于实验室排放限值.     

雨水管道沉积物中典型无机氮的干期粒径分布

以南京江北新区分流制雨水管道沉积物为研究对象,考察不同粒径沉积物中铵态氮（NH₃-N）和硝态氮（NO₃^--N）干期分布特征,分析其随干期长度的变化关系,并探讨沉积物理化性质及微生物菌群结构对NH₃-N和NO₃^--N干期分布的影响.结果表明：粒径≤0.075mm的沉积物中NH₃-N占比最高（交通区30.8%,商业区36.7%）;交通区粒径≤0.075mm的沉积物中NO₃^--N占比最高（33.0%）,而商业区粒径0.075~0.15mm沉积物中NO₃^--N占比最高（34.4%）;干期长度与交通区0.075~0.15mm粒径段的沉积物中NO₃^--N含量及商业区粒径≥0.3mm的沉积物中NH₃-N含量之间的相关性均最显著;雨水管道沉积物中NH₃-N和NO₃^--N的干期分布与O-H和N-H等官能团、表面极性和亲水性、微观形貌等有一定关联;交通区雨水管道沉积物中Gemmobacter等反硝化优势菌种（相对丰度总和为20.15%）对NO₃^--N干期分布影响更显著.     

Role of glycine on sulfuric acid-ammonia clusters formation: Transporter or participator

Glycine(Gly) is ubiquitous in the atmosphere and plays a vital role in new particle formation(NPF).However,the potential mechanism of its on sulfuric acid(SA)-ammonia(A)clusters formation under various atmospheric conditions is still ambiguous.Herein,a(Gly)_x·(SA)_y·(A)_z(z≤x+y≤3) multicomponent system was investigated by using density functional theory(DFT) combined with Atmospheric Cluster Dynamics Code(ACDC) at different temperatures and precursor concentrations.The results show that Gly,with one carboxyl(-COOH) and one amine(-NH_2) group,can interact strongly with SA and A in two directions through hydrogen bonds or proton transfer.Within the relevant range of atmospheric concentrations,Gly can enhance the formation rate of SA-A-based clusters,especially at low temperature,low [SA],and median [A].The enhancement(R) of Gly on NPF can be up to 340 at T=218.15 K,[SA]=10~4,[A]=10~9,and [Gly]=10~7 molecules/cm~3.In addition,the main growth paths of clusters show that Gly molecules participate into cluster formation in the initial stage and eventually leave the cluster by evaporation in subsequent cluster growth at low [Gly],it acts as an important "transporter" to connect the smaller and larger cluster.With the increase of [Gly],it acts as a "participator" directly participating in NPF.     

Development of a static test apparatus for evaluating the performance of three PM2.5 separators commonly used in China

PM_(2.5) separator directly affects the accuracy of PM_(2.5) sampling.The specification testing and evaluation for PM_(2.5) separator is particularly important,especially under China's wide variation of terrain and climate.In this study,first a static test apparatus based on polydisperse aerosol was established and calibrated to evaluate the performance of the PM_(2.5) separators.A uniform mixing chamber was developed to make particles mix completely.The aerosol concentration relative standard deviations of three test points at the same horizontal chamber position were less than 0.57%,and the particle size distribution obeyed logarithmic normal distribution with an R~2 of 0.996.The flow rate deviation between the measurement and the set point flow rate agreed to within ± 1.0% in the range of -40 to 50℃.Secondly,the separation,flow and loading characteristics of three cyclone separators(VSCC-A,SCC-A and SCC112) were evaluated using this system.The results showed that the 50% cutoff sizes(D_(50)) of the three cyclones were 2.48,2.47 and 2.44 μm when worked at the manufacturer's recommended flow rates,respectively.The geometric standard deviation(GSD) of the capture efficiency of VSCCA was 1.23,showed a slightly sharper than SCC-A(GSD = 1.27),while the SCC112 did not meet the relevant indicator(GSD = 1.2 ± 0.1) with a GSD = 1.44.The flow rate and loading test had a great effect on D_(50),while the GSD remained almost the same as before.In addition,the maintenance frequency under different air pollution conditions of the cyclones was summarized according to the loading test.     

Revealing the changes of bacterial community from water source to consumers tap: A full-scale investigation in eastern city of China

This study profiled the bacterial community variations of water from four water treatment systems, including coagulation, sedimentation, sand filtration, ozonation-biological activated carbon filtration (O₃-BAC), disinfection, and the tap water after the distribution process in eastern China. The results showed that different water treatment processes affected the bacterial community structure in different ways. The traditional treatment processes, including coagulation, sedimentation and sand filtration, reduced the total bacterial count, while they had little effect on the bacterial community structure in the treated water (before disinfection). Compared to the traditional treatment process, O₃-BAC reduced the relative abundance of Sphingomonas in the finished water. In addition, ozonation may play a role in reducing the relative abundance of Mycobacterium. NaClO and ClO₂ had different effects on the bacterial community in the finished water. The relative abundance of some bacteria (e.g. Flavobacterium, Phreatobacter and Porphyrobacter) increased in the finished water after ClO₂ disinfection. The relative abundance of Mycobacterium and Legionella, which have been widely reported as waterborne opportunistic pathogens, increased after NaClO disinfection. In addition, some microorganisms proliferated and grew in the distribution system, which could lead to turbidity increases in the tap water. Compared to those in the finished water, the relative abundance of Sphingomonas, Hyphomicrobium, Phreatobacter, Rheinheimera, Pseudomonas and Acinetobacter increased in the tap water disinfected with NaClO, while the relative abundance of Mycobacterium increased in the tap water disinfected with ClO₂. Overall, this study provided the detailed variation in the bacterial community in the drinking water system.     

Fast and efficient aqueous arsenic removal by functionalized MIL-100(Fe)/rGO/δ-MnO2 ternary composites: Adsorption performance and mechanism

Because of its significant toxicological effects on the environment and human health,arsenic(As) is a major global issue.In this study,an Fe-based metal-organic framework(MOF)(Materials of Institut Lavoisier:MIL-100(Fe)) which was impregnated with reduced graphene oxide(rGO) by using a simple hydrothermal method and coated with birnessitetype manganese oxide(δ-MnO_2) using the one-pot reaction process(MIL-100(Fe)/rGO/δ-MnO_2 nanocomposites) was synthesized and applied successfully in As removal.The removal efficiency was rapid,the equilibrium was achieved in 40 min and 120 min for As(Ⅲ) and As(Ⅴ),respectively,at a level of 5 mg/L.The maximum adsorption capacities of As(Ⅲ) and As(Ⅴ) at pH 2 were 192.67 mg/g and 162.07 mg/g,respectively.The adsorbent revealed high stability in pH range 2-9 and saturated adsorbent can be fully regenerated at least five runs.The adsorption process can be described by the pseudo-second-order kinetic model and Langmuir monolayer adsorption.The adsorption mechanisms consisted of electrostatic interaction,oxidation and inner sphere surface complexation.